Bosch Dishwasher E15 Error Code – Causes and How to Fix It

Bosch Dishwasher E15 Error Code – Causes and How to Fix It

Quick answer

How do I fix E15 on a Bosch dishwasher?

Turn off the power and water, soak up the water in the base pan behind the toe-kick panel, and let it dry for 24 hours. Use the right amount of dishwasher detergent, then restore power and run a short cycle. If E15 comes back, there is a leak that a technician needs to find.

An E15 code on a Bosch dishwasher means water has collected in the base pan under the tub. A float switch in the base detects it, and Bosch’s leak protection shuts the dishwasher down and runs the drain pump so water doesn’t reach your floor. Sometimes the cause is a real leak; often it’s just too many suds or a splash during a cycle. Either way, the water in the base has to dry out before the code will clear.

Safety First

Turn off the dishwasher at the breaker before you tilt it or reach underneath. Close the water supply valve, usually under the kitchen sink. Water and electrical parts sit close together in the base, so don’t work on it with the power on.

Step 1: Turn Off the Power and Water

  1. Switch off the dishwasher’s breaker (or unplug it if it plugs in under the sink).
  2. Close the hot water valve that feeds the dishwasher.
  3. Put towels on the floor in front of the dishwasher.

Step 2: Dry Out the Base

You have two options:

  • Remove the toe-kick panel (the strip at the bottom front, usually two screws) and soak up the water in the base pan with towels or a sponge. On many models you can see the white float through the opening.
  • Tilt the dishwasher. If the unit is not secured tightly and you can do it safely, gently tilt it back about 45 degrees so water in the base runs out. Many built-in units are screwed to the counter, so don’t force it.

Then leave the power off and the door slightly open for 24 hours so the base and float dry fully. A hair dryer on low aimed at the toe-kick opening can speed this up, but don’t heat any plastic parts directly.

Step 3: Check the Detergent

Too many suds is one of the most common causes of E15. Suds spill over the tub into the base. Check that:

  • you use dishwasher detergent only, never dish soap from the sink;
  • you aren’t adding a pod and powder;
  • dishes were not pre-rinsed with lots of hand-wash soap still on them;
  • the rinse aid dispenser cap is closed and not overfilled.

Step 4: Reset and Test

  1. Turn the water valve back on.
  2. Turn the breaker on and wait a minute.
  3. Run a short or quick cycle with the dishwasher empty and watch the floor and the toe-kick area.

If the cycle finishes with no E15, you’re done.

What If the E15 Code Keeps Coming Back?

If E15 returns after the base is dry and the detergent is right, there is a real leak inside. Common sources are:

  • Door seal that is worn, torn or not seated.
  • Circulation pump or drain pump seal.
  • Hoses and clamps inside the cabinet.
  • Water inlet / Aquastop valve leaking at the connection.
  • Cracked spray arm or tub fitting sending water into the base.

Finding the leak means taking the side or base panels off and running the dishwasher while watching. That’s a job for a technician.

Other Bosch Dishwasher Codes You Might See

CodeMeaningFirst step
E24Drain hose or drain blockedCheck the drain hose and sink connection
E25Drain pump blockedClean the filter and the pump cover
E09Heating problemReset; run hot water at the sink first
E22Filter blockedClean the filter and the sump

For drain codes, see our Bosch dishwasher E24 and E25 error guide. Bosch has its own E15 help page and a full dishwasher error code list.

When to Call a Pro

Call a technician if E15 comes back after drying the base, if you see water on the floor, or if the dishwasher won’t drain at all. A slow leak under a built-in dishwasher can damage flooring and cabinets, so it’s worth fixing early.

See our Bosch appliance repair page and our dishwasher repair service.

Book a repair: call 437-662-1414 or book a visit online. We’re open 7 AM to 11 PM every day, statutory holidays included, at the same price, and we serve Toronto, North York, Scarborough and Etobicoke. The $70 service call (plus HST) is waived when you go ahead with the repair, and if a part has to be ordered, the return visit is free. Warranty depends on the part and the manufacturer. We’ve been fixing appliances since 2004 with licensed, insured and certified technicians. Read our Google reviews.

Frequently Asked Questions

How do I fix E15 on a Bosch dishwasher?

Turn off the power and water, soak up the water in the base pan behind the toe-kick panel, and let it dry for 24 hours. Use the right amount of dishwasher detergent, then restore power and run a short cycle. If E15 comes back, there is a leak that a technician needs to find.

Why does my Bosch dishwasher keep showing E15?

Either the base hasn’t fully dried, or water is still getting into it. Too many suds, a worn door seal, a pump seal or a loose hose are the usual causes.

Can I use my Bosch dishwasher with an E15 error?

No. The leak protection stops the cycle and runs the drain pump. It won’t wash until the base is dry and the code clears.

Can dish soap cause E15?

Yes. Regular dish soap makes a lot of suds, which spill into the base and trip the float switch. Only use dishwasher detergent.