Ice Maker Not Working? How to Find and Fix the Problem

Ice Maker Not Working? How to Find and Fix the Problem

Quick answer

Why is my ice maker not making ice?

Check that the ice maker is switched on, the freezer is cold enough (about -18 C), the water supply is open and the fill tube isn't frozen. A clogged water filter or a failed inlet valve are the next most common causes.

An empty ice bin is annoying, especially when the rest of the fridge works fine. Most ice maker problems come down to water, temperature, or a simple switch, and many are easy to fix yourself. Work through these checks in order.

Safety First

Unplug the fridge or switch off its breaker before removing the ice maker, working near its wiring, or thawing a frozen fill tube. Turn off the water shut-off valve before checking or disconnecting the supply line. Never use a sharp tool to break up ice in the ice maker; you can damage the mould, the sensor or the evaporator.

1. Is the Ice Maker Turned On?

  • Many ice makers have a wire bail arm (shut-off arm). If it’s raised, the ice maker stops. Lower it.
  • Others have an on/off switch on the ice maker, or an “Ice Off” setting on the display. Check both.
  • Some models have a “Sabbath” or vacation mode that turns off the ice maker.

2. Is the Ice Maker New or Recently Reset?

A newly installed fridge or ice maker can take 24 hours or more to start making ice. Discard the first few batches, which may contain debris from new water lines.

3. Check the Freezer Temperature

The ice maker needs a cold freezer, usually -18°C (0°F). Many ice makers won’t cycle if the freezer is warmer. If the freezer isn’t cold, see our guide to a freezer not freezing.

4. Check the Water Supply

  • Shut-off valve: make sure the valve to the fridge is fully open. It’s usually under the sink or behind the fridge, sometimes in the basement.
  • Supply line: pull the fridge out carefully and check for kinks, especially after cleaning or moving it.
  • Saddle valve: older installations often use a piercing saddle valve, which can clog over time.
  • Water pressure: low pressure causes small cubes or no ice. Check that the dispenser flows strongly.

Test the dispenser, if your fridge has one. If water dispenses normally, the supply is probably fine, and the problem is in the ice maker or its fill tube.

5. Replace the Water Filter

A clogged filter restricts water flow, causing small, hollow or no cubes. If it’s been more than six months, or the manual’s recommended interval, replace it. Use a compatible filter, and seat it fully. Some fridges need a filter reset on the display afterward.

6. Check for a Frozen Fill Tube

The fill tube carries water into the ice maker mould. If it freezes, no water gets in. Signs: the ice maker cycles but no ice forms, or there’s ice around the fill tube opening at the back of the ice maker.

How to thaw it:

  1. Unplug the fridge, and turn off the water.
  2. Locate the fill tube where it enters the ice maker.
  3. Use a hair dryer on low, held at a distance, to melt the ice. Keep water away from wiring. Or let it thaw naturally with the freezer door open and towels down.
  4. Restore power and water.

A tube that freezes repeatedly may point to low water pressure, a leaking inlet valve, or a freezer that’s too cold.

7. Clear Ice Jams

Ice can jam in the ice maker, the auger, or the chute, especially when the bin hasn’t been used for a while and cubes fuse together. Remove the bin, discard clumped ice, and clear the chute with a plastic utensil. Some Frigidaire and Electrolux models display a code such as DI SP, which commonly indicates an ice jam in the dispenser.

8. Small, Hollow or Misshapen Cubes

These usually indicate low water flow: a clogged filter, partially closed valve, kinked line or a failing water inlet valve. A freezer that’s too warm can also cause hollow cubes.

9. Error Codes

Some fridges show ice maker or water codes. On LG, Er gF commonly indicates a water flow sensor issue, and Er IF commonly indicates an ice maker fan issue. Check your manual for your model.

Quick Diagnosis Table

SymptomTry this first
No ice at allBail arm, ice maker switch, water valve, freezer temperature
Dispenser works, no iceFrozen fill tube, ice maker
No water, no iceSupply valve, kinked line, filter, inlet valve
Small or hollow cubesFilter, water pressure
Ice clumps or jamsEmpty bin, clear the chute
Ice tastes badReplace the filter, clean the bin

Keep It Working

  • Replace the filter on schedule.
  • Use ice regularly, or empty the bin every few weeks.
  • Clean the ice bin occasionally with warm water.
  • Keep the freezer at -18°C.

When to Call a Pro

Call a technician if the ice maker still won’t make ice after you’ve checked the water supply, filter and freezer temperature; if the fill tube keeps freezing; or if water leaks around the ice maker. Water inlet valves, ice maker assemblies, fans and controls can all be replaced.

See our refrigerator repair service, and our LG and Whirlpool repair pages. If water is also leaking, see our fridge leaking water guide.

Book a repair: call 437-662-1414 or book a visit online. We’re open 7 AM to 11 PM every day, statutory holidays included, at the same price, and we serve Toronto, North York, Scarborough and Etobicoke. The $70 service call is waived when you go ahead with the repair, and our repairs carry a 3 to 6 month warranty depending on the job. We’ve been fixing appliances since 2004 with licensed, insured and certified technicians. Read our 350+ Google reviews.

Frequently Asked Questions

Why is my ice maker not making ice?

Common causes include a raised shut-off arm, the ice maker being switched off, a closed water valve, a clogged filter, a frozen fill tube, or a freezer that isn’t cold enough.

Why does my ice maker make small or hollow cubes?

Low water flow is the usual cause, from a clogged filter, partially closed valve, kinked supply line, or a failing water inlet valve.

How long does it take a new ice maker to make ice?

It can take 24 hours or more after installation. Discard the first few batches.

How do I unfreeze my ice maker fill tube?

Unplug the fridge, turn off the water, and gently warm the fill tube with a hair dryer on low, keeping water away from wiring. Or let it thaw naturally.