Bosch Dishwasher E22 Error Code – How to Clean a Blocked Filter

Bosch Dishwasher E22 Error Code – How to Clean a Blocked Filter

Quick answer

How do I fix E22 on a Bosch dishwasher?

Turn off the dishwasher, twist out the filter, and scrub both filters under warm water with a soft brush. Clear any debris from the sump, refit the filter until it locks, then switch off the breaker for 10 minutes. If E22 comes back with a clean filter, the pump or a sensor needs testing.

An E22 code on a Bosch dishwasher means the filter is blocked. Food scraps, grease, broken glass or a label from a jar are stopping water from circulating, so the dishwasher can’t wash properly. You might also notice dirty water left in the bottom, gritty dishes or a bad smell. This is one of the easiest Bosch codes to fix yourself: in most cases, a good filter cleaning is all it takes.

Safety First

Turn off the dishwasher before you reach into the sump. Watch out for broken glass in the filter area. Wear gloves if you aren’t sure what’s down there.

Step 1: Remove the Filter

  1. Turn the dishwasher off and pull out the bottom rack.
  2. Find the round filter in the floor of the tub, usually at the back or centre.
  3. Turn the cylinder counter-clockwise and lift it out. The flat mesh filter comes out with it or lifts out next.

Step 2: Clean the Filter Properly

  1. Rinse both filters under warm running water.
  2. Scrub the fine mesh gently with a soft brush or old toothbrush. Grease film is easy to miss; it looks clean but blocks water.
  3. For heavy grease, soak the filter for 10 minutes in hot water with a little dish soap, then rinse well so no soap is left.
  4. Don’t use a wire brush; it can tear the mesh.

Step 3: Clear the Sump

Look into the hole where the filter sat. Remove any food, glass or seeds with a gloved hand or a spoon. Under the sump there’s a small drain pump cover on many models. If you’ve also had drain problems, our Bosch E24 and E25 guide explains how to check the pump.

Step 4: Check the Spray Arms

  1. Spin the lower and upper spray arms by hand. They should turn freely.
  2. Look at the spray holes. If they’re blocked with debris, clear them with a toothpick.
  3. Make sure tall items, pots or pan handles aren’t stopping the arms from turning.

Step 5: Refit and Reset

  1. Put the flat filter back, then push in the cylinder and turn it clockwise until it locks. A filter that isn’t locked can let debris into the pump.
  2. Switch off the breaker for 10 minutes, then switch it back on.
  3. Run a quick cycle and check the code is gone.

How Often Should You Clean the Filter?

Bosch recommends checking the filter regularly. As a rule, clean it every month, or every two weeks if you run the dishwasher daily or don’t scrape plates. Scrape food into the bin before loading, but you don’t need to pre-rinse.

What If the E22 Code Keeps Coming Back?

  • Circulation pump that’s weak or partly blocked.
  • Drain pump not removing dirty water, so the filter clogs quickly.
  • Sensor fault giving a false E22.
  • Kitchen drain backing up into the dishwasher.

Other Bosch Dishwasher Codes You Might See

CodeMeaningFirst step
E15Water in the base pan (leak protection)Power off, dry the base for 24 hours
E24Drain hose or drain blockedCheck the drain hose and sink connection
E25Drain pump blockedClean the filter and the pump cover
E09Heating problemReset; run hot water at the sink first

See our Bosch E15 guide, Bosch E09 guide and dishwasher not cleaning properly. Bosch also has an E22 help page and a full error code list.

When to Call a Pro

Call a technician if E22 comes back with a clean, locked filter, if the dishwasher hums but doesn’t spray, or if water stays in the bottom after a cycle. Pump and sensor tests need the dishwasher pulled out and the base opened.

See our Bosch appliance repair page and our dishwasher repair service.

Book a repair: call 437-662-1414 or book a visit online. We’re open 7 AM to 11 PM every day, statutory holidays included, at the same price, and we serve Toronto, North York, Scarborough and Etobicoke. The $70 service call (plus HST) is waived when you go ahead with the repair, and if a part has to be ordered, the return visit is free. Warranty depends on the part and the manufacturer. We’ve been fixing appliances since 2004 with licensed, insured and certified technicians. Read our Google reviews.

Frequently Asked Questions

How do I fix E22 on a Bosch dishwasher?

Turn off the dishwasher, twist out the filter, and scrub both filters under warm water with a soft brush. Clear any debris from the sump, refit the filter until it locks, then switch off the breaker for 10 minutes. If E22 comes back with a clean filter, the pump or a sensor needs testing.

Where is the filter on a Bosch dishwasher?

It’s in the floor of the tub under the bottom rack. Turn the round cylinder counter-clockwise to lift it out.

How often should I clean my Bosch dishwasher filter?

About once a month, or every two weeks if you use the dishwasher every day.

Can I run my Bosch dishwasher without the filter?

No. Debris would go straight into the pumps and can damage them. Always refit and lock the filter before running a cycle.