Bosch Dishwasher Error Codes: Complete List, Meanings & Troubleshooting Guide

Bosch Dishwasher Error Codes: Complete List, Meanings & Troubleshooting Guide

Quick answer

What are the most common Bosch dishwasher error codes?

The most common are E15 (water in the base), E24 and E25 (not draining), E22 (filter blocked) and E09 (heating fault). Many can be cleared by cleaning the filter, drying the base or checking the drain hose, then resetting at the breaker.

Bosch dishwashers show an E followed by two numbers when something goes wrong. On some models, the code appears on the display; on others, you see a flashing light and the code shows when you open the door. Most Bosch codes fall into four groups: leaks, draining, filters and heating. This guide lists the common Bosch dishwasher error codes, what each one means and the safe checks you can do yourself.

Safety First

Turn off the dishwasher at the breaker before you remove the filter, the toe-kick panel or anything under the sink. Never remove panels or touch wiring with the power on. Close the water valve under the sink if you see water on the floor.

Bosch Dishwasher Error Codes Chart

CodeMeaningFirst step
E15Water in the base pan; leak protection is onPower off, soak up the water in the base and dry for 24 hours
E24Water isn’t draining (hose or drain)Check the drain hose for kinks and the sink connection
E25Drain pump blockedClean the filter and the pump cover under it
E22Filter blockedRemove and scrub the filters, clear the sump
E09Heating circuit faultReset at the breaker; run hot water at the sink first
E01 / E04 / E05Heater or control electronics fault (varies by model)Reset at the breaker; call if it returns
E14Water level / flow sensor problemReset; a technician should test the sensor
E16 / E17Water inlet problem (water still flowing, or too much)Turn off the water supply and call
E21Circulation pump blocked or faultyCheck for glass or debris in the sump; reset

Codes can vary between Bosch series and model years. Read the exact code carefully: a zero and the letter O look alike on some displays. Bosch’s dishwasher error code list lets you check your model.

Leak Protection: E15

Water has reached the base pan under the tub, often from too many suds or a worn seal. Turn the power off, dry the base and leave it for 24 hours. Full steps in our Bosch dishwasher E15 guide.

Drain Codes: E24 and E25

E24 usually means the drain hose is kinked or the sink drain or garbage disposal connection is blocked. E25 means the drain pump itself is blocked, often by glass or a seed. See our Bosch E24 and E25 error guide, plus our post on a dishwasher not draining by brand.

Filter Code: E22

The filter is clogged, so water can’t circulate. Twist out the filter, scrub it and clear the sump. Our Bosch E22 guide shows how.

Heating Code: E09

The water isn’t heating properly. A reset sometimes clears it, but a repeat E09 usually means the heater pump needs replacing. Read our Bosch E09 guide.

How to Reset a Bosch Dishwasher

  1. Press and hold Start (or Reset, depending on the model) for 3 to 5 seconds to cancel the cycle and drain.
  2. Switch the dishwasher off at the breaker for 5 to 10 minutes.
  3. Switch it back on, wait a minute and start a quick cycle.

A reset only clears the display. If the cause is still there, the code comes back.

Keep Codes Away

  • Clean the filter every month.
  • Only use dishwasher detergent, and don’t overdose.
  • Scrape plates into the bin, but don’t pre-rinse with dish soap.
  • Run the kitchen tap hot before starting a cycle.
  • If the dishwasher drains into a garbage disposal, run the disposal first.

When to Call a Pro

Call a technician if a code returns after a reset and the basic checks, if there’s water on the floor, or if the dishwasher hums but doesn’t wash or drain. Pumps, heaters, sensors and the control board all need testing inside the dishwasher.

See our Bosch appliance repair page and our dishwasher repair service, or book a visit.

Book a repair: call 437-662-1414 or book a visit online. We’re open 7 AM to 11 PM every day, statutory holidays included, at the same price, and we serve Toronto, North York, Scarborough and Etobicoke. The $70 service call (plus HST) is waived when you go ahead with the repair, and if a part has to be ordered, the return visit is free. Warranty depends on the part and the manufacturer. We’ve been fixing appliances since 2004 with licensed, insured and certified technicians. Read our Google reviews.

Frequently Asked Questions

What are the most common Bosch dishwasher error codes?

The most common are E15 (water in the base), E24 and E25 (not draining), E22 (filter blocked) and E09 (heating fault). Many can be cleared by cleaning the filter, drying the base or checking the drain hose, then resetting at the breaker.

How do I reset my Bosch dishwasher?

Hold Start or Reset for 3 to 5 seconds to cancel and drain, then switch the dishwasher off at the breaker for 5 to 10 minutes before starting a new cycle.

Why does my Bosch dishwasher show a code with the door open?

On models with controls on the top edge of the door, the code only shows when you open the door. A flashing light on the front is a sign to check.

Is it worth repairing a Bosch dishwasher?

Usually, yes. Bosch dishwashers last a long time, and common repairs such as pumps, seals and heaters cost much less than a new built-in dishwasher.